Automatic label dispenser Label Combi-130 (Super Wide), Barcode Printer, QR Code Printer _ Made in KOREA
Label_Combi
USD $322.61
USD $358.20
- Brand:
- Label_Combi
- Product Code:
- Labelcombi_130
- Availability:
- In Stock
Description
Label Combi 130 is 30mm wider and can be applied to almost all labels except large labels.
*This is a semi-large class that can be applied even to exceeding the range of Label Combi-100. It is suitable when the label is a little larger than the general purpose or when you want a larger width with two or more rows.
Size: 166*174*280mm
Feeding Speed: 80mm/sec
Label size: 5-130mm
Max label roll diameter: pl 250ml
Usable label material: any material
Power and power consumption: AC 220V / 53W
Label Combi 130 Installation Instructions
1. With the power switch on the right rear side turned off, pull the locking lever forward to release it.
2. Hang the label roll on the mounting bar.
3. Bend the label strip into a “U” shape and thread it through the middle bar of the label guider.
4. After lifting the separator unit, wrap the label strip and place it between the three feet of the inner coiler, then lower the separator unit.
5. After aligning the label strip, lift the locking lever and gently push it up to the locking part when you hear a “click” sound, then turn on the power switch.
How to use the label combi 130 operation panel
- Label length adjustment: Press "UP" or "DOWN" button to turn on "Separation Length- LED GREEN". Depending on the size of the figure, it is separated and the length at which it comes out and stops is adjusted.
- Normally, "Counter-LED RED" is lit and the counter number with the label removed is displayed. At this time, if you press the "Counter Reset" button, the value becomes "0".
- Error Clear: If the label is not detected after a certain period of time, the motor stops rotating and the numerical display part blinks. At this time, press the "Counter Reset" button to cancel.
- Adjust Speed: Press the "UP" and "DOWN" buttons at the same time for about 5 seconds, the red and green LEDs blink alternately, and the displayed value is the motor speed. Adjust from 1 to 10 using the "UP" and "DOWM" buttons. (Usually, the maximum speed is set to "10".)
0 reviews
There are no reviews for this product.